|
(A ) LCD Display (2 lines) ( B ) Mode Selection Switch for Soil pH or Resistivity ( C ) Bell Hole Probe or Subsurface Probe Connection ( D ) Battery Door on Back of Case ( E ) Calibration Switch ( F ) On/Off Switch |
Specifications |
Meter | |
Dimensions |
7.5 x 4.75 x 2.25 inches |
Weight |
2.5 lbs without probe(s) |
Environmental Protection |
ABS high-impact plastic, corrosion proof, sealed to NEMA4 / IP64 |
Resistivity Range |
0 to 1.5 Mohm-cm |
Resistivity Accuracy |
± 0.5% of reading |
pH Range |
3 to 10 standard units |
pH Accuracy |
± 0.5 standard units |
Display |
LCD, 2 lines x 16 characters |
Switches |
NEMA4 / IP64 sealed toggle switches |
Power Supply |
4 AA alkaline batteries for approximately 100 hours of continuous operation |
Temperature & Humidity |
-15 to 60ºC operating, 0-100% RH, non-condensing |
Probes | |
Bell Hole Probe |
T-handle, 12 inches by 5/8-inch diameter shaft of carbon steel construction with ¾-inch diameter measurement sensor for pH and resistivity; probe wire with coiled cable for direct connection to soil probe meter. |
Subsurface Probe |
T-handle, 40 inches by 5/8-inch diameter shaft of carbon steel construction with ¾-inch diameter measurement sensor for pH and resistivity; probe with cradle for direct connection to soil meter. |
Protective Case | |
Case |
Watertight, crush proof, and dust proof with easy-open, double-throw latches, open-cell core with solid-wall design, o-ring seal, fold down handles, stainless steel hardware and padlock protectors. |
Outside Dimensions |
53 x 16 x 6-¼ inches |
Lid & Back |
Double-walled construction for added crush resistance and strength. |
Weight |
20 pounds without soil probe meter, bell hole probe, subsurface probe or accessories. |
Inside Case |
Fitted with 2.2-pound density polyethylene foam. Foam insert is molded to fit the soil probe meter, bell hole probe, subsurface probe, maintenance kit and soil probe meter manual. |